Yongnuo YN-622C User's Guide download pdf (Page 41)

The Other YN-622C User Guide v.4.07

23/07/2014

Part III – C-TX Controller Page 41 of 62

MANUAL Mode

Set Group Manual Output

[Left] [Right] [Up] [Down]

• Ensure that the required Group is active and in M mode.

• Default is 1/16 output

• Then use [Left], [Right], [Up], [Down] to change Manual output from 1/1 to 1/128.

• Setting mode will time-out.

MULTI / Stroboscopic Mode

Enable Multi

[E/M], [E/M]

Set up the camera for Multi as described in its owner

manual. The flashes should have Manual levels and not be

E-TTL-only.

• Long press [E/M] twice. The “Multi” screen will show:

Group A’s output level in row 1

Frequency per second (Hz) in row 2

Firing count in row 3.

• The default value is:

Group A Output 1/16

Frequency 1

Count “---“ (= “until shutter closes”).

• Press [Left], [Right], [Up] or [Down] to change the value.

• Press [Gr] to move to the 2nd row to change the global frequency per second.

• Press [Gr] to move to the 3rd row to change the global count.

• Use the camera’s Flash Control menus to set Manual outputs for groups B and C.

• While the Multi screen is open, the function is active.

• Long press [E/M] to cancel Multi and return to Groups.

SHUTTER SYNC MODES

Set Sync mode [Sync]

• Default is Hi-Speed (HSS).

• Press [Sync] repeatedly to cycle through

Hi-speed sync (HSS)

Curtain sync (1CS) - (no icon)

Curtain sync (2CS)

• The setting mode will quickly time-out.

Super Sync requires HSS to be enabled. It is discussed in the

C-TX Features section on p.43.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 61 62

No comments

Yongnuo YN-622C User's Guide Page 41