Yongnuo YN-622C User's Guide download pdf (Page 26)

The Other YN-622C User Guide v.4.07

23/07/2014

Part II – 622C Transceivers Page 26 of 62

622C TRANSCEIVER CONTROL MODES

REMOTE & MIX

The original YN-622C transceiver can work in either of two modes – Remote or Mix.

Remote Mode implements standard Canon wireless protocols.

Mix Mode can work with E-TTL and manual modes together, but loses the ability to manage

manual levels from the camera.

Setting the Mode

• The Remote/Mix mode is set only on the transmitter 622C, not on any remote 622Cs.

• Do not try to set or un-set Mix mode using the buttons on remote receivers.

• To switch between Remote Mode and Mix Mode, hold down [CH SET] on the transmitter

622C until the channel indicator has winked red/green 3 times.

• In standby, the channel indicator will:

Stay off in Remote Mode

Stay lit in Mix Mode.

• The last-used setting is remembered by the Transmitter unit during power-down

Warning: If a different 622C is later used as the Transmitter, it may have remembered different

settings!

Camera Remote Mode

• Type A camera External Flash menus take priority over most on-flash settings.

• Class 1 flashes are controlled by the camera’s menus.

• Class 2 to 5 flashes are controlled by the local on-flash settings.

• Flash Mode is set in-camera and may be E-TTL or Manual or Multi.

• The CH indicator is off when in standby to indicate Remote mode.

• This is the Factory default mode.

On-Flash Mix Mode

• The local on-flash settings take priority. E-TTL and Manual can be mixed.

• All Classes of flash may be used. Each flash (including an on-TX flash) can be set locally

on-flash to E-TTL, Manual or Multi depending on the flash’s capabilities.

• Flash mode is fixed in-camera to E-TTL.

• FEC, FEB, Ratio and Shutter sync can be set in-camera.

• The camera’s zoom setting is disabled. Each flash will use its own setting.

• If the shutter sync mode is set by the camera menu, the on-flash setting is ignored. A Type

B camera defaults to hi-speed sync.

• The CH indicator stays lit when in standby to indicate Mix Mode.

• Any flash set to E-TTL will emit a preflash. If its mode is Manual or Multi, it won't.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 61 62

No comments

Yongnuo YN-622C User's Guide Page 26