Yongnuo YN-622C User's Guide download pdf (Page 46)

The Other YN-622C User Guide v.4.07

23/07/2014

Part III – C-TX Controller Page 46 of 62

Enable Proxy Mode [Fn] 06 Proxy

Proxy mode allows the C-TX to be slaved to a YN560-TX Manual-only Controller. The C-TX then

forwards the commands to flashes on remote 622Cs.

• The YN560-TX is mounted on the camera, and controls remote YN560 III Manual-only

flashes

• A stand-alone C-TX can receive those commands and forward them to remote 622Cs.

• Proxy mode is available in a C-TX with firmware v.1.02 or later.

• The channel on the YN560-TX, YN622C-TX and YN622C remotes must be the same.

• The flashes on the 622Cs must be in Manual mode.

• Long press SYNC/FN key to enter the custom function and go to FN.06 (Up/Down key).

• Change the value to ON (Left/Right.

• Place the YN622C-TX anywhere within the transmission range of YN560-TX.

• Use YN560-TX to control Manual output/zoom of the ettl flashes on YN-622C remotes.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 61 62

No comments

Yongnuo YN-622C User's Guide Page 46