Yongnuo YN-622C User's Guide download pdf (Page 36)

The Other YN-622C User Guide v.4.07

23/07/2014

Part III – C-TX Controller Page 36 of 62

C-TX CONTROL MODES

There are three control modes available.

Remote Control

This is the primary control method. Groups, flash modes, sync modes, FEC or M output can be set

remotely.

Local Control

Settings for Flash Mode and its parameters are made on-flash, which then over-rides the remote

settings.

Basic Trigger

The C-TX can be used as a sync-only radio trigger. The settings for a Manual output level are

made on flash. The highest-speed shutter sync is 1/250s or lower, depending on the camera.

• The C-TX can be mounted on a single-contact hot-shoe camera

• The C-TX can be mounted on a multi-contact hotshoe camera, using a multi-pin to single-

pin adapter.

• The C-TX can be connected to a camera’s PC-sync-out port using an appropriate cable.

• The highest sync speed is 1/250S or less; HSS is not available.

• Configure Groups and Output levels in Manual mode to create desired lighting.

Fuji Cameras

• Some Fuji cameras will work in Remote Manual Control.

• Fuji X100, X100S and X-E1 have been reported to work in full remote Manual output and

Zoom control, in 3 groups.

• High-speed sync up to 1/1000s has been reported.

• TTL and 2

curtain sync is not available.

• The 622Cs are set to Remote mode.

• Compatible flashes, like the 580EXII must be used.

• The above cameras do not need Custom Function 04 Legacy Flash to be ON. The function

is required when the C-TX thinks that it is on a full E-TTL camera.

• Care is required when mounting the C-TX on the camera to ensure that the pins ride up

and seat fully.

• Press the Test button after changing C-TX settings to update the remotes, before pressing

the shutter.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 61 62

No comments

Yongnuo YN-622C User's Guide Page 36