Yongnuo YN-622C User's Guide download pdf (Page 28)

The Other YN-622C User Guide v.4.07

23/07/2014

Part II – 622C Transceivers Page 28 of 62

Flash Exposure Lock (FEL)

• The camera must be in a creative mode.

• Live View mode must be disabled.

• Flash mode must be E-TTL.

• First focus on subject.

• Then press the camera’s [*] or [FEL] or [M-Fn] button, or as custom re-configured.

• Flash metering temporarily changes to Spot metering. The ambient and flash exposures

are locked into the camera for 16 seconds, or while [half-shutter] remains pressed.

• “FEL” appears momentarily, and the <Flash> icon and “*” are lit in the viewfinder. The

values are discarded when the shot is taken, or a hi-speed burst ends.

• If the subject is too far away and underexposure may result, the <Flash> icon will blink in

the viewfinder. Move closer to the subject and try the FE lock again.

Flash Exposure Bracketing (FEB)

• Set FEB in 1/3 f/stop increments up to -2 to +2 f/stops (-3 to +3 f/stops on 2012 and later

cameras).

• The zero point for FEB is adjusted by the global FEC setting.

• The sequence of FEB is fixed at 0 minus plus, even when the on-flash setting is

different.

• The FEB function will be automatically cancelled after the three shots are taken.

• An E-TTL flash which does not support FEB can also be used.

MANUAL MODE

User-determined Output Levels; No Metering

Remote Manual Levels

Type A camera menus can remotely control Mk II Speedlites and YN flashes.

• All (global), groups A and B, or A, B and C.

• Output levels 1/1 to 1/128, by Group

• E-TTL Flashes do not emit a pre-flash

All Flashes (Global setting)

• Set Flash Mode to Manual.

• Set Flash Output as required, 1/1 to 1/128 output level, in 1/3 f/stop increments.

• Either set Wireless function to Disable, or Enable Wireless with Firing Group A+B+C.

Two and three Receiver groups

• Set Flash Mode to Manual.

• Ignore Flash Output: it will repeat group A setting.

• Set Wireless function to Enable.

• Set Firing Group to A:B (C will not fire) or A:B C.

• Set each Group Output as required, 1/1 to 1/128 output level, in 1/3-f/stop increments.

• On-TX flash will fire at group A level, if Master Flash is enabled.

On-Flash Manual Levels

Type A, B or C cameras can trigger flashes where the output level has been set on-flash.

• Flash connected by PC-sync cable.

• Output levels set on individual flash.

• E-TTL Flashes will not emit a pre-flash

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 61 62

Comments to this Manuals

No comments

Yongnuo YN-622C User's Guide Page 28

Comments to this Manuals

Related products and manuals for Camera accessories Yongnuo YN-622C