Yongnuo YN-622C Datasheet download pdf (Page 23)

1. Hold down the [CH SET] button for several seconds of the

transmitter until the channel indicator blinks for 3 times and

then keep lighting, enable the mix control mode.

2. Flash mode of the transmitter will be fixed at E-TTL and the

zoom setting is disabled.

3. Set the parameters of each flashes via it own control panel.

Mix Control Mode

Set the flash on each receiver in different flash modes as

Manual/E-TTL/Multi for mix control, the settings of the flash

is prior , channel indicator of the transmitter will keep

lighting when enabled this control mode. Supports type A/B

cameras using.

In the mix control mode, set items via the flash it

supports: Flash mode (output), FEB, FEC, Zoom etc.

Set the shutter sync via camera menu and the flash

set is invalid (Type B camera defaults to hi-speed sync).

※ Disable the mix control mode by hold down [CH

SET] button again then it will return to remote

control mode (the channel indicator goes out in

standby state).(p.11)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30 31

No comments

Yongnuo YN-622C Datasheet Page 23